tag:blogger.com,1999:blog-4149454435568723766.post4613334553496738354..comments2023-10-30T23:35:14.248+01:00Comments on NetHomeServer: Sensing waterUnknownnoreply@blogger.comBlogger4125tag:blogger.com,1999:blog-4149454435568723766.post-22699864073998983752022-03-23T08:30:45.405+01:002022-03-23T08:30:45.405+01:00Nice Blog, Thank you for your this blog. Keep it u...Nice Blog, Thank you for your this blog. Keep it up <a href="http://www.rich-security.com/" rel="nofollow">Float level sensor</a>Rich Security Technology(HK) Co., Limitedhttps://www.blogger.com/profile/12366761370133896863noreply@blogger.comtag:blogger.com,1999:blog-4149454435568723766.post-72252435910716862502015-05-14T11:05:13.425+02:002015-05-14T11:05:13.425+02:00I got it going. I missd a solder point and did not...I got it going. I missd a solder point and did not relise recognize that the humidity sensor did not work unless temperature circuit was reading correctly. I also quickly learned that the humidity readings vary with temperature readings..johmeihttps://www.blogger.com/profile/03318241748363924312noreply@blogger.comtag:blogger.com,1999:blog-4149454435568723766.post-81341239682596947952015-05-14T10:59:10.736+02:002015-05-14T10:59:10.736+02:00Hi. I currently just use the temperature sensor fo...Hi. I currently just use the temperature sensor for soil moisture measurement. The "sensors" I use now are thin metal spikes (legs from resistors) that I have put shrinkable tubing (krympslang) around so only about 5 mm of the metal is exposed in the end. I place them about 10 cm apart in the pot, but I adjust the distance so the impedance becomes correct. Hope this helps!NetHomeServerhttps://www.blogger.com/profile/07935568088800525265noreply@blogger.comtag:blogger.com,1999:blog-4149454435568723766.post-7336533788184288122015-05-13T10:34:59.301+02:002015-05-13T10:34:59.301+02:00Hi,
I am trying to make soil moisture sensors out ...Hi,<br />I am trying to make soil moisture sensors out of one of my temp/humidity sensors that looks exactly like the one you used but from ClasOhlsson. I have connected wires from the board to nails in the soil. The problem I face is that the readings are HI or LO, I never get into the right resistance window. How do I figure out the resistance to use for the temp circuit and humidity circuit?johmeihttps://www.blogger.com/profile/03318241748363924312noreply@blogger.com